Crowtail - Vibration Sensor 2.0 (Grove Compatible)

This new Crowtail module (Grove compatible) can simplify the connections in your project and make your life easier! Say goodbye to messy wiring and incorrect pin connections, as the Crowtail module features a standard pin arrangement and can only be plugged in one way.

This module is based on the SW-420, a widely used normally closed-type vibration sensor in vehicle theft alarms, smart cars, earthquake alarms, etc. Compared to the normally open-type vibration sensor module, this sensor's vibration triggers for longer periods of time and can drive a relay module. This sensor produces a digital output signal when any vibration is detected.

You can use Crowtail modules with any microcontroller or HAT that comes with a Grove port. For example:

• Maker UNO RP2040
• Maker Pi Pico
• Maker Pi RP2040
• EDU:BIT
• EDU PICO
• Grove Base Shield V2
• Grove Base for Raspberry Pi 

• Grove compatible
• Single-bus digital output
• High-precision vibration sensor
• Low power consumption
• Cost-effective

Specifications:

• Operating Voltage: 3.3V / 5V
• LM393 wide voltage comparator
• Digital Output (High or Low)
• Dimension: 40mm x 20mm x 7.6mm (L x W x H)

• 1 x Crowtail Vibration Sensor
• 1 x Crowtail 4-Pin Cable

Note: Crowtail cable is the same as Grove cable.

• Crowtail Vibration Sensor Wiki Page