Description
This is an OEM 7-inch capacitive touchscreen display for Raspberry Pi that has similar specifications to the official 7-inch screen from Raspberry Pi.
The 800x480 display connects via an adapter board that handles power and signal conversion. Only two connections to the Pi are required; power from the Pi’s GPIO port and a ribbon cable connecting to the DSI port on all Raspberry Pi. Touchscreen drivers with support for 5-finger touch and an on-screen keyboard will be integrated into the latest Raspbian OS for full functionality without a physical keyboard or mouse. If you like to keep it in a nice casing, check this Premium Case for this Screen.
Device and System Supported:
- Raspberry Pi main boards:
- Supports Raspbian, 5-points touch, driver free
- Supports Ubuntu / Kali / WIN10 IoT, single point touch, driver-free
- Supports Retropie, driver free
Installation Guide:
1. Connect the DSI interface of the 7-inch DSI LCD to the DSI interface of Raspberry Pi with an FPC cable.
2. Use the 2PIN power cable to connect the power interface of the LCD to the 40PIN GPIO interface of the Raspberry Pi, as below:
3. You can fix the Raspberry Pi on the backside of the 7-inch DSI LCD with screws. The installation effect is shown in the following figure:
Warranty Period: 12 months
Features
- 7-inch TFT screen with a hardware resolution of 800 x 480.
- Capacitive touch panel supports 5-point touch.
- Supports:
- As it directly drives LCD by the DSI interface of Raspberry Pi, the refreshing rate is up to 60Hz.
- Supports Raspberry Pi OS / Ubuntu / Kali and Retropie when used with Raspberry Pi, drive-free.
- Backlight is adjustable via the software.
Dimension:
.jpg )
Packing List
- 1 x 7 Inch DSI Capacitive Touchscreen
- 2 x FPC 15pin 1.0 pitch 5cm (opposite sides)
- 1 x PH2.0 2-pin wire 10cm
- 1 x Screws pack
Tags: DSI screen,
touchscreen,
7" screen,
capacitive screen,
capacitive touchscreen,
RPi display
International
Singapore
Malaysia
Thailand
Vietnam
