NEO-M6 GPS and microSD Shield for Arduino

GPS positioning is becoming more and more popular to use. This is a GPS positioning shield that is compatible with the Arduino MCU.

It is based on the NEO-6M-0-001 module. the GPIO pins are compatible with Arduino UNO R3 and MEGA 2560 control board. Regular GPS pins (RX, TX) are connected to Arduino D0-D7, and you are able to set the connection pin via the jumper cap. An active antenna is mounted on the GPS shield, allowing you to find your exact location within a few meters. Meanwhile, GPS also provides you with a very accurate time!

It can be used in car navigation, personal positioning, fleet management, and navigation.

Note: For best results, the GPS HAT needs to be outdoor with a clear sky to lock the location. You will not get the exact location with an indoor setup.

• Based on u-blox NEO-6M GPS module
• Connecting TxD and RxD to Arduino pins (D0-D8 optional) with jumper, and the default jumper caps are D7<-->RX and D6<-->TX.
• Onboard comes with an SD card socket
• Comes with an ICSP pin
• Comes with a reset button to reset the Arduino control board
• GPS shield dimensions: 54mm*53mm*24mm
• Antenna dimensions: 28mm*28mm*7mm
• Antenna lead length: 142mm

Packing list:

• 1 x NEO-M6 GPS and microSD Shield for Arduino
• 1 x Antenna

• Product wiki page
• Libraries
• Sample code