Grove - Button

Note: From March 2021 onwards, the Grove Button module is updated to V1.2 from V1.0.

The version update:

• ASD function is removed but you can achieve this function through software programming.
• Added voltage surge protection circuit.

This Grove - Button is a momentary push button configured with pull-down resistor. It contains one independent "momentary on/off" button. “Momentary” means that the button rebounds on its own after it is released. The button outputs a HIGH signal when pressed, and LOW when released. The SIG marked on silk layer stands for signal while NC(No Connection) stands for not used at all.

For all Grove users (especially beginners), we provide you guidance PDF documents. Please download and read through Preface - Getting Started and Introduction to Grove before your use of the product.

Ready to use with microcontrollers as digital input. This product also has a compact modular design Plug-and-play grove compatible interface.

Based on picture above, the grove shield for Arduino is stacked with Seeeduino V4.2. Of course you can use that shield with Arduino too :)

You can get grove HAT for Raspberry Pi here. It may not be the same as product above but still can use with Raspberry Pi.

Note: Controllers are sold separately.

• Easy to use momentary ON/OFF button
• Uses Standard 4-pin Grove Cables
• Operating voltage: 3.3V / 5V
• Electrical life: 200,000 cycles
• Operation temperature: -25℃ to +70℃
• Dimensions: 20mm x 20mm

• Grove - Button
• Grove 4 Pin Buckled 20cm Cable

• Grove - Introduction to Grove
• Grove - Button connection and code with Arduino and Raspberry pi by wiki.seeedstudio
• Grove - Button tutorial (You can get that grove shield for Arduino here)