With the launch of ESP32-S2 that comes with enhanced security features and USB interface, it has been a hot topic for maker community and industry developer to check it out.
Cucumber RIS is a WiFi IoT development board based on the latest ESP32-S2 chipset from Espressif (ESP32-S2-WROVER-I).
The RIS version is using external antenna via u.FL connector (antenna included). It is a special version that includes many on-board sensors. Example:
HS221 Temperature & Humidity sensor
MPU-6050 3-axis Accelerometer
3-axis Gyroscope
BMP280 Pressure sensor
It is packed with many goodies. Example:
2 x USB Type-C (One for debugging and another is OTG-On the Go)
FTDI chip for USB-to-Serial converter which highly compatible with most computers
RGB LED which uses only one signal line and can mix up to over 16 million colors for the TX/RX, IO2, and PWR LED
Colorful sticker to indicate the pin function
Cucumber MI come in a nice clear plastic box for ease of storage.
Note: This is the Cucumber RIS version on board. It comes with External IPEX Antenna, 4MB Flash, 2MB of PSRAM, and comes with sensors.
Features:
Based on ESP32-S2 Chipset, ESP32-S2-WROVER-I
Two USB-C, one for debugging and another as On the Go
ESP32-S2 offers secure boot based on the RSA Algorithm
Secure encryption based on the AES-XTS algorithm (4096-bit)
TLS stack can take advantage of the cryptographic accelerator hardware
Reinforced and resists fault injection attacks
Crypto: AES-128/192/256. SHA-2, RSA, RNG, HMAC, Digital Signature
Support ToF (Time of Flight)
Low Power
Support ESP RainMaker: an End to End platform that enables Makers to realize their IoT ideas faster with ESP32-S2.
International
Singapore
Malaysia
Thailand
Vietnam
-800x800.jpg "USB C to Type A Cable (1 Meter)")
